TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013
TM-9-2815-205-24

  TM-9-2815-205-24 - Page 624 of 856

REMOVAL
1.
Thread two 3/8-16 eye bolts (Figure 1, Item 9) into tapped holes located in pads at sides of flywheel housing
(Figure 1, Item 24). Attach sling (Figure 1, Item 6) to eye bolts.
2.
Remove eight screws (Figure 1, Item 21), eight lockwashers (Figure 1, Item 22), and eight flat washers
(Figure 1, Item 23) from area inside bell of flywheel housing (Figure 1, Item 24). Discard lockwashers.
3.
Thread two studs (Figure 1, Item 20) into cylinder block inside bell area of flywheel housing
(Figure 1, Item 24).
4.
Remove two small self-locking bolts (Figure 1, Item 19), two flat washers (Figure 1, Item 18), four large self-
locking bolts (Figure 1, Item 13), and four flat washers (Figure 1, Item 15) from area inside bell of flywheel
housing (Figure 1, Item 24). Discard bolts.
5.
Remove two screws (Figure 1, Item 12), two lockwashers (Figure 1, Item 11), and two flat washers
(Figure 1, Item 10) from upper right side of flywheel housing (Figure 1, Item 24). Discard lockwashers.
6.
Remove two nuts (Figure 1, Item 1), two lockwashers (Figure 1, Item 2), two screws (Figure 1, Item 8), and
two flat washers (Figure 1, Item 7) from upper left side of flywheel housing (Figure 1, Item 24).
Discard lockwashers.
7.
Remove eight screws (Figure 1, Item 14), eight lockwashers (Figure 1, Item 16), and eight flat washers
(Figure 1, Item 17) from sides of flywheel housing (Figure 1, Item 24). Discard lockwashers.
WARNING
Components of this engine are heavy and awkward to handle. Use correct lifting
procedures, indicated lifting devices, and/or assistance from other personnel. Failure to
comply may result in injury to personnel.
8.
Strike front face of flywheel housing (Figure 1, Item 24) alternately on each side with a soft head hammer.
Loosen housing and work off dowel pins (Figure 1, Item 26).
9.
Guide flywheel housing (Figure 1, Item 24) off studs (Figure 1, Item 20) and remove from engine using sling
(Figure 1, Item 6).
10.
Remove sling (Figure 1, Item 6) and eye bolts (Figure 1, Item 9) from flywheel housing (Figure 1, Item 24).
11.
Remove studs (Figure 1, Item 20) from cylinder block.
12.
Remove flywheel housing gasket (Figure 1, Item 5), shim (Figure 1, Item 25), and gasket (Figure 1, Item 4)
from end plate (Figure 1, Item 3). Discard gaskets.
TM 9-2815-205-24
0088
0088-2


Back to Top