TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 171 of 596

TM 9-2815-205-34

3-12. AIR BOX HEATER HARDWARE REPLACEMENT (MODEL 5063-5393) (Cont)

(10)

(11)

(12)

(13)

(14)

(15)

(16)

(17)

(18)

Connect terminals of harness assembly (12) to solenoid valve (14) and top of ignition coil (16).

Install two harness assembly leads (54 and 55) and two nuts (18 and 19) on air pump (20).

Install three ground wires of harness assembly (12), copper washer (11), and bolt (10) in air

box heater (13). Torque bolt to 13-17 Ib-ft (18-23 N

.

m).

Install terminal of harness assembly (12), clip (25), screw (24), two flat washers (23),

Iockwasher (22), and nut (21) in top of bracket (26). Torque nut to 30-35 Ib-ft (41-47 N

.

m).

Connect ignition wire (15) to spark igniter (17) and bottom of ignition coil (16).

If removed, install adapter (8) in hose (7).

Install check valve (5) in hose (7). Connect adapter (8) to elbow (9) in air box heater (13).

Tighten adapter.

Place check valve (5) in loop clamp (4) and install loop clamp,

flat washer (3), Iockwasher (2),

and screw (1) into rent cover (6). Torque screw to 30-35 lb-ft (41-47 N

.

m).

Install wire wrap (27) around ignition wire (15), hose (28), and harness assembly (12).

3-46