TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 162 of 596

TM 9-2815-205-34

d. Installation

(1)

(2)

Lay harness assembly (11) in position on front of engine.

Place angle bracket (42) over front of air inlet housing (70) and against upper front cover (29).

Install two Iockwashers (66) and two long screws (65) in top of bracket and install two flat

washers (69), two Iockwashers (68), and two short screws (67) in front of bracket. Torque

screws (65) to 16-20 Ib-ft (22-27 N

.

m) and screws (67) to 46-50 Ib-ft (62-68 N

.

m).

(3)

(4)

(5)

NOT E

To torque screws (61), it is necessary to loosen center bolt (75) on bracket assembly

(64) and move air pump and ignition coil. Torque center bolt (75) to 60-96 lb-in (7-11

N-m).

Install bracket assembly (64), four flat washers (63), four Iockwashers (62), and four screws

(61) on angle bracket (42). Torque bolts to 30-35 Ib-ft (41-47 N

.

m).

If removed, install loop clamp (52), connector (60), tee (59), pipe nipple (57), and pipe plug (58)

on air inlet hose (53). connect hose to elbow (56) in air pump (37). Tighten connection.

Install two screws (51), two loop clamps (54) on top of bracket, loop clamp (52) on bottom of

bracket, two Iockwashers (50), and two nuts (49) on angle bracket (42). Torque screws to

30-35 Ib-ft (41-47 N

.

m).

3-37