TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 159 of 596

TM 9-2815-205-34

3-11. AIR BOX HEATER HARDWARE REPLACEMENT (MODEL 5063-5392) (Cont)

(9)

(10)

(11)

(12)

(13)

(14)

(15)

(16)

(17)

3-34

Remove bolt (23), copper washer (24), and grounding wires of harness assembly (11) form air

box heater (15). Discard copper washer.

Remove screw (25), Iockwasher (26), flat washer (27), and loop clamp (28) from front cover

(29). Discard Iockwasher.

Disconnect air hose (30) from check valve (31) and adapter (32) from elbow (33) in air box

heater (15). If necessary, remove adapter from hose.

Disconnect ignition wire (34) from ignition coil (35) and spark igniter (36).

Remove two nuts (73 and 74) and disconnect two leads of harness assembly (11) from air

pump (37).

Disconnect harness assembly (11) from ignition coil (35).

Remove nut (38), Iockwasher (39), screw (40), and clip (41) from angle bracket (42). Discard

Iockwasher. If necessary, remove clip from harness assembly (11).

Remove nut (43), Iockwasher (44), two flat washers (45), screw (46), and clip (47) from angle

bracket (42). Discard Iockwasher.

Remove clip (28) and wire wrqp (48) holding harness assembly (11), ignition wire (34), and air

hose (30) together. Remove air hose, ignition cable, and harness assembly from engine.