TM-9-2815-205-34

TM-9-2815-205-34 - Page 154 of 596

TM 9-2815-205-34

(9) Install fuel line (50) in elbow (51), at solenoid valve (7), and in elbow (52) on air box heater

body (34). Tighten connections.

(10)

Wind wire wrap (48) around ignition coil

cable (39), air hose (15), and harness

assembly (49). If removed, install clip (38)

on air hose (15).

(11) If removed, install adapter (18) into hose assembly (15). Connect hose assembly to check

valve (16) and adapter end to elbow (17) at air box heater body (34). Tighten connections.

(12) Install connector (19) in solenoid (7) and connector (20) in ignition coil (21).

(13) Install wiring harness lead (28), Iockwasher (24), and nut (22) on terminal (26). Install lead (29),

Iockwasher (25), and nut (23) on terminal (29) on air pump (30). Tighten nuts securely.

(14) Install ground wires (33), copper washer (32), and bolt (31) on air box heater body (34). Torque

bolt to 13-17 Ib-ft (18-23 N-m).

(15) Install clip (38), on air hose (15), flat washer (37), Iockwasher (36), and screw (35) on upper

front cover. Torque screw to 30-35 Ib-ft (41-47 N

m).

(16) Connect boot end of ignition coil cable (39) to igniter (40) and connector end of ignition coil

cable to ignition coil (21).

(17) Install screw (43), flat washer (44), Iockwasher (42), and nut (41) in bracket (46) and support

(47). Torque nut to 30-35 Ib-ft (41-47 N

m).

3-29