TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 169 of 596

TM 9-2815-205-34

3-12. AIR BOX HEATER HARDWARE REPLACEMENT (MODEL 5063-5393) (Cont)

d. Installation

(1) Lay harness assembly (12) in position on front of engine.

(2) Place mounting bracket (26) over front of air inlet housing (52) and against upper front cover

(6). Install two flat washers (48), two Iockwashers (47), and two long screws (46) into top of

bracket and install two flat washers (51), two Iockwashers (50), and two short screws (49) into

front of bracket. Torque screws (46) to 16-20 Ib-ft (22-27 N

.

m) and screws (49) to 46-50 Ib-ft

(62-68 N-m).

NOT E

T

O

torque screws (42), it is necessary to loosen center bolt (53) on bracket assembly

(45) and move air pump and ignition coil. Torque center bolt to 60-96 lb-in (7-11 N

.

m).

(3) Install bracket assembly (45), four flat washers (44), four Iockwashers (43), and four screws

(42) on mounting bracket (26). Torque bolts to 30-35 Ib-ft (41-47 N

.

m).

3-44