TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 330 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

Using hammer and blunt chisel,

drive damaged ring gear (1) from flywheel (2).

WARNING

Use welder’s gloves when handling hot ring gear (3).

CAUTION

Do not use cutting torch to heat ring gear (3). Use

heating torch to avoid damage to gear. Do not heat

ring gear to more than 400°F. Temperatures above

400°F will soften gear.

Use Tempilstick to measure heat.

Using heating torch, heat inner surface of new ring gear (3) until 400°F.

Tempilstick melts when touched to side of new ring gear.

Using hammer and brass drift, quickly drive heated ring gear (3) onto

flywheel (2).

END OF TASK

4-311