TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 338 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

2.

3.

4.

5.

Check that two pipe plugs (1), square head pipe plug (2), and two valve

plugs (3) are not cracked and do not have damaged threads. Check that

square head of square head pipe plug is not rounded. If pipe plugs,

square head pipe plug, or valve plugs are damaged, throw them away and

get new ones.

Check that 16 mounting screws (4) and long mounting bolt (5) do not have

stripped or damaged threads or rounded heads. Check that 16 mounting

washers (6) and mounting washer (7) are not cracked or broken. Throw

away damaged screws, bolt, and washers and get new ones.

Check that two springs (8) are not cracked or squeezed shut. If two springs

are cracked or squeezed shut, throw them away and get new ones.

WARNING

Dry cleaning solvent is flammable. D

O

not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel and

damage to equipment.

Check that two plungers (9) have no scratches or burrs. Fix small burrs and

scratches with crocus cloth dipped in dry cleaning solvent. Polish two

plungers with crocus cloth dipped in dry cleaning solvent even if they are not

scratched.

Check that two plungers (9) fit and move freely in bores in oil cooler and

filter housing (10).

If plungers bind in bores, throw away plungers and get

new ones.

If new plungers still bind in bores, get a new oil cooler and filter

housing.

GO TO FRAME 4

4-319