TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 571 of 704
0052-61
Change 1
TB 9-3950-253-13&P
0052
LIGHT BAR ASSEMBLY INSTALLATION – CONTINUED
NOTE
•
Install mounting plate as shown for PLS. When installing on HEMTT, flip mounting plate
horizontally.
•
Ground wire is on PLS only.
17. At center of rear slider beam (Figure 63, Item 1), install mounting plate (Figure 63, Item 2), and two screws
(Figure 63, Item 11) on slider beam.
18. Route light wire (Figure 63, Item 6) along slot on mounting plate (Figure 63, Item 2) while installing light.
19. Install light (Figure 63, Item 10), ground wire (Figure 63, Item 4), and screw (Figure 63, Item 3) on mounting
plate (Figure 63, Item 2).
20. Install ground wire (Figure 63, Item 9) from vehicle wiring harness (Figure 63, Item 8), and screw (Figure 63,
Item 5) on mounting plate (Figure 63, Item 2).
21. Connect light wire (Figure 63, Item 6) to vehicle wiring harness connector (Figure 63, Item 7).
Figure 63.
Slider Beam Light Installation.
052
1
2
3
4
5
6
7
8
9
10
11
Back to Top
