TM-5-2350-377-14-P

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)

TM-5-2350-377-14-P - Page 120 of 335

TM 5-2350-377-14&P

HEADLIGHT LENS HOLDER AND LIGHT FILTER, LIGHT LENS, AND RUBBER ROUND SEAL

REPLACEMENT - continued

Figure 8.

Headlight Light Filter.

ASSEMBLY

NOTE

Steps 1 through 5 apply to Figure 8.

1.

Clean rubber round section groove (item 1) in holder (item 2) with solvent (Item 7, WP 0055 00) and rag (Item17,

WP 0055 00).

2. Put front lip (item 3) of lens (item 4) in inside groove of new seal (item 5).

3. Put lens (item 4) with seal (item 5) in lens and filter holder (item 6).

Make sure lens (item 4) and seal (item 5) are

seated firmly in holder (item 6).

NOTE

Put filter on lens so wide ends of markings face up when holder is installed on body.

4. Lay painted side of filter (item 7) on top of lens (item 3).

5. Put plate (item 8) on top of filter (item 7).

Install three screws (item 9) in plate (item 8) and holder (item 6).

0018 00-3

0018 00