TM 5-2350-377-14&P
HEADLIGHT LENS HOLDER AND LIGHT FILTER, LIGHT LENS, AND RUBBER ROUND SEAL
REPLACEMENT - continued
NOTE
Steps 3 through 4 apply to Figure 7.
3. Remove three screws (item 5) from plate (item 6).
Figure 7.
Headlight Lens Holder.
4. Remove plate (item 6), filter (item 9), lens (item 8), and seal (item 7) from holder (item 2).
WARNING
Cleaning solvent (PF05) is combustible.
Wear protective goggles and gloves; use only
in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe
vapors.
Keep away from heat or flame.
Never smoke when using cleaning solvent;
the flashpoint is 144°F (62°C).
Failure to follow this warning may result in injury or death
to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help.
If solvent contacts skin or clothes, flush with cold water.
If solvent
contacts eyes, immediately flush them with water and get immediate medical
attention.
When PF05 cleaning solvent is used, notify the local medical authority (preventive
medicine) and environmental coordinator concerning medical surveillance, respiratory
protection, and disposal requirements.
0018 00
0018 00-2
5
3
6
7
9
8
2