TM-5-2350-377-14-P

ARMORED COMBAT EARTHMOVER (ACE), M9

TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)

TM-5-2350-377-14-P - Page 121 of 335

TM 5-2350-377-14&P

0018 00-4

HEADLIGHT LENS HOLDER AND LIGHT FILTER, LIGHT LENS, AND RUBBER ROUND SEAL

REPLACEMENT - continued

Note

Steps 6

through 11

apply to Figure 9.

6. Install new rubber round section (item 10) in groove (item 11) of holder (item 2).

Ends of rubber round section

(item 10) should overlap.

Figure 9.

Headlight Round Rubber Seal.

7. Cut ends of rubber round section (item 10)

at an angle where they meet in groove (item 11).

Remove rubber round

section (item 10).

8. Apply adhesive in groove (item 11) with brush (Item 6, WP 0055 00).

Put rubber round section (item 10) in groove

(item 11) so ends overlap where they are cut.

9. Put plate spacer (item 12) on holder (item 2).

Install four screws (item 13) on headlight (item 14).

10. Put holder (item 2) on body (item 14).

Loosely install five screws (item 13).

11. Align four holes (item 12) in holder (item 2) with mounting lugs (item 15) on body (item 2).

Tighten five screws

(item 13).

END OF WORK PACKAGE

0018 00