TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 127 of 335
TM 5-2350-377-14&P
HEADLIGHT SUPPORT REPLACEMENT - continued
2. Remove three screws (item 5), lockwashers (item
6) and washers (item 7) from support (item
8) and headlight body
(item 1).
3. Gently take support ( item
8) off body (item 1) while pushing connector (item
2) through hole (item
4) in support
(item 8).
4. Remove gasket (item 3) from support (item 8) and body (item 1).
5. Clean off any gasket material from body (item 1) with solvent (Item 7, WP 0055 00), wire brush (Item 5, WP 0055
00), and rag (Item 17, WP 0055 00).
Figure 14.
Headlight Support Assembly.
ASSEMBLY
NOTE
Steps 1 through 4 apply to Figure 14.
1. Apply sealant
adhesive (Item 1, WP 0055 00) on new gasket ( item 3) with acid swabbing brush (Item 4, WP 0055
00).
Position gasket (item 3) on support (item 8).
2. Feed connector (item 2) through hole (item 4) in support (item 8).
Install jamnut (item 9) to connector (item 2).
3. Position body (item 1) on support (item 8).
Install three screws (item 5), new lockwashers (item 6), and washers
(item 7) to support (item 8) and body (item 1).
4. Install left or right headlight assembly (WP 0016 00, Assembly).
END OF WORK PACKAGE
0021 00
0021 00-2
5
7
8
3
2
1
9
4
6
Back to Top
