TM-9-1200-215-34-P
AUTOMATIC FIRE CONTROL SYSTEM (AFCS)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
FEBRUARY 1999
TM-9-1200-215-34-P - Page 116 of 266
TM 9–1200–215–34&P
4–2
4–5.
SERVICE UPON RECEIPT OF MATERIEL CONTINUED
b.
Check unpacked equipment.
(1)
Inspect the equipment for damage incurred during shipment.
If the equipment has been damaged,
report the damage on SF 364, Report of Discrepancy.
(2)
Check the equipment against the packing slip to see if the shipment is complete.
Report all
discrepancies in accordance with the instructions of DA PAM 738–750.
c.
Processing unpacked equipment.
Enter unpacked and checked equipment into normal work schedule based
on standard shop practice.
Section
III – PRE–SHOP ANAL
YSIS.
Page
Page
Introduction
4–2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pre–Shop Analysis
4–2
. . . . . . . . . . . . . . . . . . . . . . . .
4–6.
INTRODUCTION
Pre–shop analysis is a method for screening incoming equipment to determine its physical condition for
maintenance tasks required to return the equipment to service.
Pre–shop analysis begins with a technical
inspection of the equipment and ends with a report of corrective actions taken.
Other than for structural
malfunctions, such as broken handles, all incoming equipment is subject to manual troubleshooting as outlined in
Section IV of this chapter.
4–7.
PRE–SHOP ANALYSIS
Using Table 4–1 and paragraph 1–11 as a guide, check for parts that are broken, cracked, bent, dented, or
missing.
Evaluate condition of assembly.
Verify that all cable receptacles are securely fastened.
Acceptable
cracks and dents should be cleaned and missing Chemical Agent Resistant Coating (CARC) should be reapplied.
WARNING
Uncured CARC paint contains hazardous materials.
Follow manufacturer’s instructions in
preparation and application of the CARC.
Failure to comply may result in injury to personnel.
Table 4–1.
Pre–Shop Analysis Guide
Item
Description
Check
Action
1
Forms and Tags
Existence.
2
Receptacle:
J1,
J2, J3, J4, J5,
J6, J7
Existence, cleanliness, corrosion, dents,
cracks, bent pins, broken or worn
connector lugs.
3
Indicator Lights
Existence, cleanliness, and cracks.
4
Enclosure
Cleanliness, corrosion, dents, cracks,
broken or missing vanes, and mounting
feet.
5
Circuit Card
Assemblies
(CCAs)
All CCAs installed; none missing.
Remove top cover per paragraph 4–13
and visually inspect for existence or
damage.
Replace missing or damaged
card.
Back to Top
