TM-9-1200-215-34-P

AUTOMATIC FIRE CONTROL SYSTEM (AFCS)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

FEBRUARY 1999

TM-9-1200-215-34-P - Page 112 of 266

TM 9–1200–215–34&P

3–21

3–18.

SERIAL CABLE ASSEMBLY MAINTENANCE INSTRUCTIONS CONTINUED

b.

INSTALLATION CONTINUED

CAUTION

The EMI shielding gasket is vital to

this piece of equipment and is easily

damaged. Handle with care when

removing or replacing it. Gasket will

break if stretched. Failure to comply

may result in damage to equipment.

7.

Remove EMI shielding gasket (15) from J1

connector (8).

8.

Inspect EMI shielding gasket (15) for cuts,

nicks, and signs of stretching. Discard EMI

shielding gasket if unserviceable.

b.

INSTALLATION

CAUTION

ESD SENSITIVE

The DU contains ESD sensitive

components. Wear a protective

ESD wrist strap whenever handling

components. Failure to comply may

result in damage to equipment.

1.

Attach ESD grounding strap to wrist and

ground, to ensure ESD protection.

CAUTION

The EMI shielding gasket is vital to

this piece of equipment and is easily

damaged. Handle with care when

removing or replacing it. Gasket will

break if stretched. Failure to comply

may result in damage to equipment.

2.

Place EMI shielding gasket (15) onto J1

connector (8).

3.

Place J1 connector (8) into position in DU

housing. Place jam nut (7) on J1 connector

and hand tighten. Torque jam nut to 95

"

5

in.–lb (10.7

"

.6 N

S

m).

8

7

15