TM-9-1200-215-34-P
AUTOMATIC FIRE CONTROL SYSTEM (AFCS)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
FEBRUARY 1999
TM-9-1200-215-34-P - Page 92 of 266
TM 9–1200–215–34&P
3–1
CHAPTER 3.
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS FOR
DISPLAY UNIT (DU)
Section
I – REP
AIR P
ARTS, T
OOLS, SPECIAL T
OOLS, TEST
,
MEASUREMENT
, AND DIAGNOSTIC EQUIPMENT (TMDE), AND
SUPPORT EQUIPMENT
Page
Page
Common Tools and Equipment
3–1
. . . . . . . . . . . . . . . . .
Special Tools, TMDE, and
Support Equipment
3–1
. . . . . . . . . . . . . . . . . . . . . . . . . .
Repair Parts
3–1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3–1.
COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE),
CTA 50–970, or CTA 8–100, as applicable to your unit.
3–2.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Refer to Appendix C, Repair Parts and Special Tools List (RPSTL) for applicable special tools, TMDE, and
support equipment.
3–3.
REPAIR PARTS
Refer to Appendix F of this manual for a list of mandatory replacement parts. Repair parts are listed and
illustrated in Appendix C of this manual.
Section
II – SER
VICE UPON RECEIPT
Page
Page
Site and Shelter Requirements
3–1
. . . . . . . . . . . . . . . . .
Service Upon Receipt of Materiel
3–1
. . . . . . . . . . . . . . .
3–4.
SITE AND SHELTER REQUIREMENTS
Display Unit DS maintenance will be performed using facilities contained within the Electronic Shop,
Transportable, AN/TSM–191(V)3.
3–5.
SERVICE UPON RECEIPT OF MATERIEL
a.
Unpacking.
(1)
Place packed Display Unit (DU) on a work bench
(2)
Check the condition of the packaged DU. Check the markings. Note any discrepancies.
(3)
Do not use sharp blades or sharp cutting tools when unpacking the DU. Remove packing material
carefully.
b.
Check unpacked equipment.
Back to Top
