TM-9-2330-202-13-P

TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

DECEMBER 2011

TM-9-2330-202-13-P - Page 257 of 552

FIELD MAINTENANCE

HYDRAULIC BRAKE LINES REPLACEMENT

INITIAL SETUP:

Tools and Special Tools

Tool Kit, General Mechanic's

(WP

0115, Table 1, Item 1)

Materials/Parts

Self-locking nut (M101A2 and M116A2 )

(WP

0092, Figure 11, Item 11)

Lockwasher

(WP

0092, Figure 11, Item 25)

Gasket, copper (WP

0092, Figure 11, Item 26)

Rag, wiping

(WP

0114, Table 1, Item 24)

References

WP

0053

WP

0078

Equipment Condition

Handbrakes applied (WP

0005)

WARNING

•

Accidental or intentional introduction of liquid contaminants into the environment is a

violation of state, federal, and military regulations. Refer to local environmental office for

information concerning storage, use, and disposal of these liquids. Failure to comply may

cause damage to environment and health of personnel. Seek medical attention in the

event of an injury.

•

When performing maintenance on brake system, make sure wheels are securely

chocked. Failure to comply may cause trailer to roll, resulting in death or injury to

personnel. Seek medical attention in the event of an injury.

NOTE

•

Use a suitable container to catch any draining brake fluid. Make sure all spills are cleaned

up. Refer to local procedures for responding to fluid spills and disposal of clean up

materials. Refer to local procedures for storage and disposal of drained fluids.

•

For information on manufacturing tube assemblies refer to (WP

0078).

TM 9-2330-202-13&P

0052

0052-1