TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 794 of 1348

INSTALLATION

NOTE

If studs were removed, perform Step (1).

1.

Install stud (Figure 5, Item 4) in hub (Figure 5, Item 5) until base of stud is seated against back edge of hub.

1

2

3

4

5

6

Figure 5.

Wheel Bearing (Service) and Hub Installation.

2.

Apply light film of grease on inside of hub (Figure 5, Item 5) and on two bearing cups (Figure 5, Item 6) and

(Figure 5, Item 3).

3.

Install two bearing cups (Figure 5, Item 6) and (Figure 5, Item 3) in hub (Figure 5, Item 5).

WARNING

Use of excessive amount of grease when lubricating wheel bearings may result in grease

contacting brake linings and cause brake failure. Failure to comply may result in injury or

death to personnel.

4.

Pack area of hub (Figure 5, Item 5) between two bearing cups (Figure 5, Item 6) and (Figure 5, Item 3) with

grease up to smallest diameter of bearing cups.

NOTE

Perform Steps (5) and (6) for hub mounted seals.

5.

Pack inner bearing (Figure 5, Item 2) with grease and install in hub (Figure 5, Item 5).

NOTE

The wider edge of seal goes on hub first.

6.

Install seal (Figure 5, Item 1) in hub (Figure 5, Item 5).

TM 9-2330-342-23&P

0092

0092-6