TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 795 of 1348

INSTALLATION - Continued

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. Keep away from open fire and use in well-ventilated

area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately

with soap and water. Failure to comply may result in injury or death to personnel.

NOTE

Perform Steps (7) through (11) for spindle mounted seals.

7.

Apply a small amount of sealing compound around wiper seal collar (Figure 6, Item 2).

1

2

2

3

1

Figure 6.

Wheel Bearing (Service) and Hub Installation.

CAUTION

Ensure wiper seal is installed evenly on wiper ring collar. Failure to comply may result in

damage to equipment.

8.

Using a soft-faced hammer and brass drift, tap evenly around base of wiper seal (Figure 6, Item 1) and install

wiper seal (Figure 6, Item 1) on wiper seal collar (Figure 6, Item 2) until edge is flush with spindle shoulder

(Figure 6, Item 3).

TM 9-2330-342-23&P

0092

0092-7