TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 355 of 528

TM 9-2330-356-14

(4) Using the 5/8-inch socket, extension, and

socket wrench, turn engine clockwise until the two

remaining bolts can be removed.

(5) Remove the two remaining bolts and washers.

(6) Using alternator belt, lift pulley out of

intermediate housing and remove belt.

Figure 6-12. Turning Engine in Crankshaft Clockwise

Direction.

b.

Installation

(Fig. 6-11).

(1) Position alternator drive belt on pulley.

(2) Position pulley and belt in intermediate

housing between the two hubs.

CAUTION

Be sure curved side of washers are against

flex plates. Bolts holding pulley to flex plates

must be tightened to 25 Ib.-ft.

(3) Apply thread sealant to two holes, and install

two bolts and four washers to hold flex plates to pulley.

Tighten bolts to 25 lb.-ft.

(4) Turn engine clockwise until the remaining

two bolts and four washers can be installed.

(5) Apply thread sealant to two remaining bolts,

and install two bolts and four washers. Tighten bolts to

25 lb.-ft.

(6) Install alternator drive belt over alternator

pulley.

(7) Install alternatorand adjust drive belt tension

(para 4-78).

6-21.

Buss Bar

a.

Removal.

Refer to paragraph 4-81.

b.

Replacement of Fuse Clip (Fig. 6-13).

(1) Use a bench grinder to remove crimped end

of rivet.

(2) Use a hammer and punch to drive rivet from

buss bar and fuse clip.

(3) Install fuse clip to the buss bar with a rivet.

Use a rivet punch to install rivet.

c.

Installation.

Refer to paragraph 4-81.

Figure 6-13. Installing Fuse Clip.

6-13/(6-14 Blank)