TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 354 of 528

TM 9-2330-356-14

(7) On the M970 and M970A1 only, connect the

75-inch cable to the U-bolt connection on valve operator

A.

(8) Thread cable through cable guide on cabinet

and connect cable to hose reel cabinet door shut-off.

(9) Adjust cable (para 4-51).

(10) Cut excess cable 1½-inches from all U-bolt

attempt to inspector repair tank until it has been drained

and purged (Chapter 4, Section XX).

b.

Inspection.

Inspect tank for leaks, punctures, or

dents.

connect ions.

6-20.

WARNING

Do not use an acetylene torch to fuse cable

a.

ends unless tank has been cleaned and

purged. Failure to follow this warning may

result in serious Injury or death to personnel.

c.

Repair.

Straighten dented metal with rubber

mallet or a block of wood and heavy hammer. Repair

cracks by welding (TM 9-237).

Alternator Drive Belt (M967, M969, and

M970)

Removal

(Pig. 6-11).

(1) Remove alternator (para 4-78).

(2) Check pulley in pump intermediate housing

(11) Unless the tank has been cleaned and purged

to ensure that the two bolts attaching flex plates to pulley

for other maintenance, crimp the cable ends to keep them

are accessible for removal. If bolts cannot be removed,

from unraveling. DO NOT fuse them unless tank has been

remove center plug from engine grille (fig. 6-12). Use a

5/8-inch socket on a long extension, and insert it through

purged.

the hole and onto fan bolt. With a socket wrench, turn

6-19. Tank Components

engine clockwise until bolts can be removed.

a.

Cleaning and Purging.

Observe safety precautions

(3) Remove two bolts and four washers holding

given in the Warning Summary at front of manual. Do not

flex plates to pulley.

Figure 6-11. Removal of Alternator Drive Belt (M967, M969, and M970).

6-12