TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 353 of 528

TM 9-2330-356-14

(8) Slide washer (8) up against bushing inside

upper leg, and install roll pin (2).

(9) Coat grease (item 17, Appendix E) heavily on

pinion and bevel gear teeth.

(10) Apply a continuous

1/8-inch diameter bead of

adhesive to inside of cover (1). Install cover (1) to upper

leg (5).

e.

In.stallation.

Install landing gear leg (para 4-54).

6-18. Emergency Valve Control Cables (Fig. 6-10)

a.

Removal.

(1) Remove

nut (3) and loosen

u-bolt

connections (9) securing cable(s) 10 valve operator A.

Remove cables.

(2) Loosen U-bolt connection securing cable to

emergency valve.

(3) Loosen U-bolt securing control cable to

emergency valve shut-off on curbside of trailer and

remove cable.

(4) On M970, M970A1 only, loosen the U-bolt

connection securing cable to cabinet door shut-off lever.

Remove cable.

(5) Pull cables through cable guides and remove

cables.

b.

Installation.

(1) Slide nut (3) over one end of the 120-inch

cable. Insert end of cable into end of adjusting bolt (4) and

tighten nut onto adjusting bolt.

(2) Thread cable through cable guide on cabinet

and U-bolt connection on emergency valve.

(3) Adjust cable (para 4-51).

(4) Connect the 168-inch cable to U-bolt

connection on valve operator A.

(5) Thread cable through cable guides and

connect to emergency valve shut-off.

(6) Adjust cable (para 4-51).

Figure 6-10. Emergency Valve Control and Cables.

6-11