TM-9-2350-277-20-5

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 5 OF 6

TM-9-2350-277-20-5 - Page 919 of 1047

TM 9-2350-277-20-5

REPAIR/REPLACE MORTAR FIRE CONTROL SYSTEM CABLES (MFCS)

(M1064A3 ONLY) — Continued

0812 14

NOTE

If fuel lines are under floor plate support, cable 3W3 may be routed above floor plate support.

20. Position P4 branch of cable 3W3 (29) under bilge pump floor plate support and along fuel valve panel. Route away

from areas where hazards for pinching exist.

CAUTION

To prevent damage to equipment, ensure power is turned off at power distribution assembly

(PDA) before connection of cable.

21. Connect P4 connector of cable 3W3 (29) to J4 connector of cable 3W2 (27) at cable bracket (28) on driver’s side

sponson.

22. Secure P4 branch of cable 3W3 (29) in bilge pump and fuel valve areas with loop clamps and tie straps as required.

0812 14-18

Change 5