TM-9-2520-254-34

TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1

TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1971

TM-9-2520-254-34 - Page 103 of 126

Figure 5-117

Figure 5-118

Figure 5-120

Figure 5-119

Install turbine assembly (A). Install coned part of

snap ring driver (B) on end of turbine shaft. Install

snap ring (C) on driver. Install knurled cap of snap

ring driver (B). (Driver is part of kit—5120-572-

8663 (8356191)).

Install bolt (A), and tighten it against cap (B) until

snap ring (C) snaps into groove (D). Remove driver

kit parts. (Bolt and cap are part of kit—5 120-572-

8663 (8356191)).

Install lockup clutch back plate (A), seal ring (B),

hook-type seal ring (C), and lockup clutch plate

(D).

NOTE

Aline balance marks (E) on converter

pump and back plate.

Using lifting strap 4910-572-8608 (8356175) (A)

and lifting eye 4910-673-8301 (10865773) (B),

install pump cover assembly (C). Do not remove

strap (A) and eye (B) at this time.

NOTE

Aline balance marks (D).

5-53