TM-9-2520-254-34
TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1
TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1971
TM-9-2520-254-34 - Page 97 of 126
Figure 5-95
Figure 5-97
Figure 5-96
Figure 5-98
Install compressor assembly 4910-572-8643
(8356187) (A), and compress reaction plate
against its springs. Install two roll pins (B) in pins
(C) so that roll pins extend
1
/
8
inch from pins
toward center. Remove compressor assembly.
Install reverse-range sun gear shaft (A) in low-
range ring gear (B), and install snap ring (C).
Install assembly on output shaft (D).
Install reverse-range clutch assembly (A) over
output shaft (B). Install spacer (C) and internal-
splined thrust washer (D).
Install reverse sun gear (A). Install snap ring (B)
and wire-type snap ring (C)
in groove
(D).
5-47
Back to Top
