TM-9-2520-254-34
TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1
TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1971
TM-9-2520-254-34 - Page 96 of 126
Figure 5-91
Figure 5-93
Figure 5-92
Figure 5-94
Install two guide bolts (A) into pitot tube (B), and
insert guide bolts into housing (C). Install reverse
planetary carrier and pitot collector ring assembly
(D) so that pitot tube (B) will be located in
collector ring at position shown by arrow head (E)
between vanes. (Guide bolts are part of set 4910-
572-8710 (8356165).)
Remove one guide bolt (A), and install a
1
/
4
-28 x
2
3
/
4
bolt (B) and plain washer to hold pitot tube in
place. Remove other guide bolt, and install other
bolt and washer. Tighten bolts to 8 to 10 pound-
feet torque. (Guide bolts are part of set 4910-572-
8710 (8356165).)
Place low and reverse piston housing assembly (A)
on work table, reverse end up. Install reverse clutch
apply plate (B), one internal-splined plate (C), and
reverse ring gear (D).
Alternately install three external-tanged (A) and
three internal-splined (B) clutch plates. Install 12
springs (C) into reaction plate (D). Install reverse
clutch reaction plate assembly (D).
NOTE
Aline anchor pin slot (E) with clutch apply
oil holes (F).
5-46
Back to Top
