TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 619 of 933

TM 9-2520-270-34

45. INSTALL SPRING RETAINER PLATE (1).

46. PLACE 10 SPRINGS (2) ON

RETAINER (1).

49. INSTALL REMAINING SIX PINS (6).

50. PLACE RIGHT-HAND OUTPUT

CARRIER ASSEMBLY (7) IN OUTPUT

HOUSING (8).

47.

48.

INSTALL INNER SPRING RETAINER (3),

a.

b.

c.

Aline retainer (3).

(H) Hold retainer (3) down.

Using 3/8-inch drive brace handle and

7/16-inch socket, install six

washers (4) and screws (5). Tighten

six screws two turns at a time to

evenly compress springs (2).

USING 1/2-lNCH DRIVE TORQUE

WRENCH WITH ADAPTER,

EXTENSION, AND 7/16-lNCH SOCKET,

TORQUE SIX SCREWS (5) TO

10-12 ft-lb (1-2 mkg).

CAUTION

Do not install brake plates without

coating with transmission oil. Equipment

can be damaged.

51. INSTALL STATIONARY SERVICE

BRAKE PLATE (9).

a. Coat plate (9) with transmission oil

before assembly.

b. Aline plate tabs (10) with pins (6).

c. Install plate (9) so it is facing same

way as removed.

4-290