TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 620 of 933

TM 9-2520-270-34

CAUTION

Do not install brake plates without coating

with transmission oil. Equipment can be

damaged.

NOTE

Plates should be installed in the same order and

facing same way as removed.

52. INSTALL ROTATING SERVICE

BRAKE PLATE (1).

a. Coat plate (1) with transmission oil

before assembly.

b. Aline plate splines (2) with splines on

carrier assembly (3).

c. Install plate (1) so it is facing

the same way as removed.

53. REPEAT STEPS 51 AND 52 UNTIL

10 STATIONARY PLATES (4) AND

9 ROTATING PLATES (1) ARE

INSTALLED.

54. INSTALL RETAINER PLATE (5).

a. Install plate (5) with bolt hole (6)

facing screw hole (7).

b. Install retaining ring (8) with slot

alined with hole (6).

55. INSTALL WASHER (9) AND BOLT (10).

a. Coat threads of bolt (10) with sealant

compound.

b. Using 3/8-inch drive brace handle and

3/8-inch socket, install washer (9) and

bolt (10) in hole (6).

56. USING 3/8-INCH DRIVE TORQUE

WRENCH AND 3/8-lNCH SOCKET,

TORQUE BOLT (10) TO 60-75 in-lb

(69-86 cmkg).

GO TO NEXT PAGE

4-291