TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 324 of 779

Fig. B-14

Table 6-6. Generator Adapter Standard and Oversize Stud Identification

Note.

Refer to figure 6-1 for oversize stu d

identification .

c.

Assembly .

Assemble generator driv e

gearshaft and adapter following instruction s

which accompany figures 6-26 and 6-27 .

1. If ball bearings were removed from generator drive

gearshift, coat ball bearing (A) with engine oil, Military

Specification MIL-L-45199, and position bearing on

flange of gearshaft. Press bearing on gearshaft.

2. Coat ball bearing (B) with engine oil, Military

Specification MIL-L-45199, and press the bearing on

the other end of the gearshaft in the same manner.

Figure 6-26. Pressing ball bearings o n

generator drive gearshaft .

6-30