TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 328 of 779

Note.

Do not use a scriber or other shar p

Note.

Care must be exercised in the handling

instrument for marking connecting rod bearin g

of the connecting rods to avoid nicks an d

halves. After bearings are removed, reassemble

scratches which act as stress risers and can lead

connecting rods and caps since they are matched

to premature failure .

units and must be kept together for inspection

2. Remove 24 connecting rod cap bolt nuts attaching rod

and installation .

caps to connecting rods (B). Remove rod caps,

1. Remove 24 cotter pins (A).

bearings, and connecting rods from crankshaft.

Figure 6-30. Removing or installing connecting rod assemblies .

6-34