TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 326 of 779

Fig. B-14

Fig. No.

B-14

B-14

B-14

B-14

B-14

B-14

B-14

B-14

B-14

B-14

B-14

B-14

Table 6-7. Generator and Starter Idler Gears Overhaul Standards

Note.

Refer to paragraph 6-3b for explanation of symbols .

c. Assembly.

Assemble generator idler gea r

following instructions which accompany figur e

6-29. The starter idler gear is similar and may be

assembled in the same manner .

1. Coat ball bearing (A) with engine oil Militar y

Specification MIL-L-45199, and position bearing in

bearing bore of generator idler gear.

2. Carefully press bearing into gear untill bearing seats

against flange in gear. Secure bearing in gear with

retaining ring (A) as shown in figure 6-28.

Figure 6-29. Pressing ball bearing int o

generator idler gear .

6-32