TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 219 of 856

REMOVAL - Continued

NOTE

Do not discard preformed packing (Figure 2, Item 18) found on front trunnion of

model 5063-5299. Store this packing in container trunnion block and use for

shipping purposes only. Use a new packing when installing engine in vehicle.

Steps 5–7 apply only to model 5063-5299, NSN 2815-01-295-7458.

5.

Remove two screws (Figure 2, Item 17), two lockwashers (Figure 2, Item 21), upper shipping trunnion block

(Figure 2, Item 20), preformed packing (Figure 2, Item 18), and lower shipping trunnion block

(Figure 2, Item 19) from front of engine. Discard lockwashers.

6.

Install two screws (Figure 2, Item 17), two lockwashers (Figure 2, Item 21), upper shipping trunnion block

(Figure 2, Item 20), and preformed packing (Figure 2, Item 18) on lower shipping trunnion block

(Figure 2, Item 19). Tighten screws.

7.

Install two screws (Figure 2, Item 16), four flat washers (Figure 2, Item 12), two lockwashers

(Figure 2, Item 11), two nuts (Figure 2, Item 10) (located in mailbag), and shipping trunnion assembly

(Figure 2, Item 15) on lower half of container (Figure 2, Item 13). Tighten screws.

15

12

16

12

11

10

13

18

17

21

20

19

MAINT_089

Figure 2.

Engine Trunnion Block Removal.

TM 9-2815-205-24

0033

0033-3