TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 189 of 596
TM 9-2815-205-34
3-16. FUEL LINES REPLACEMENT (MODEL 5063-5299)
This task covers: a. Removal
b. installation
INITIAL SETUP
MODELS
MATERIALS/PARTS
5063-5299
1
Lockwasher (App F, Item 99)
TOOLS AND SPECIAL TOOLS
EQUIPMENT CONDITION
Tool kit, general mechanics (App B, Item 107)
Para Description
Wrench, torque (App B, Item 116)
3-10 Air pump support removed
3-14 Coolant crossover tube removed
a. Removal
(1)
(2)
(3)
Remove screw (1), Iockwasher (2), flat
washer (3), and clip (4), on fuel relet hose
assembly (5), from air inlet housing (6).
l
Discard ockwasher. If necessary, remove
clip from hose assembly.
Disconnect fuel inlet hose assembly (5)
from tee (7) at rear of left cylinder head
and from elbow (8) at front of right
cylinder head. Remove hose assembly.
Loosen nuts on two elbows (9) at front of
cylinder heads and remove fuel crossover
tube (10).
b. Installation
(1)
(2)
(3)
(4)
Insert fuel crossover tube (10) into two
elbows (9) at front of cylinder heads.
Tighten nut on each elbow.
Connect fuel inlet hose assembly (5) to
elbow (8) at front of right cylinder head
and to tee (7) at rear of left cylinder head.
Tighten hose connections.
If removed, install clip (4) on fuel inlet
hose assembly (5).
Install clip (4), located on fuel inlet hose
assembly (5), flat washer (3), Iockwasher
(2). and screw (1) on air inlet housing (6).
Torque screw to 16-20 Ib-ft (22-27 N
.
m).
END OF TASK
FOLLOW-ON MAINTENANCE
Para
3-14
3-10
3-60
Description
Install coolant crossover
Install air pump support.
tube.
Back to Top
