TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 191 of 596
TM 9-2815-205-34
3-17. FUEL LINES REPLACEMENT (MODEL 5063-5392)
This task covers: a. Removal
b. Installation
INITIAL SETUP
MODELS
MATERIALS/PARTS
5063-5392
1
Lockwasher (App F, Item 99)
TOOLS AND SPECIAL TOOLS
EQUIPMENT CONDITION
Tool kit, general mechanics (App B, Item 107)
Para Description
Wrench, torque (App B, Item 116)
3-11 Air pump assembly and support removed
3-14 Coolant crossover tube removed
a. Removal
(1)
(2)
(3)
(4)
(5)
(6)
Remove screw (1), Iockwasher (2), and clip (3), on hose assembly (4), from air inlet housing
(5). Discard Iockwasher. If necessary, remove clip from hose assembly.
Disconnect hose assembly (4) from tee (6) at rear of left cylinder head and from elbow (7) at
front of right cylinder head.
Remove hose assembly. If necessary, remove two clips (8) from
hose assembly.
Disconnect hose assembly (9) from tee (6) at rear of left cylinder head. Remove hose
assembly.
Disconnect hose assembly (10) from elbow (11) in fuel pump (12). Remove hose assembly.
Disconnect hose assembly (13) from elbow (14) in fuel pump (12). Remove hose assembly.
Loosen nuts on two elbows (15) at front of cylinder heads and remove fuel crossover tube (16).
b. Installation
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Insert fuel crossover tube (16) into two elbows (15) at front of cylinder heads. Tighten nut on
each elbow.
Connect hose assembly (10) to outboard elbow (11) in fuel pump (12). Tighten hose
connection.
Connect hose assembly (13) to inboard elbow (14) in fuel pump (12). Tighten hose connection.
Connect hose assembly (9) to tee (6) in fuel inlet at rear of left cylinder head. Tighten hose
connection.
If removed, install two clips (8) on hose assembly (4). Connect hose assembly to tee (6) in fuel
inlet at rear of left cylinder head and to elbow (7) at front of right cylinder head. Tighten hose
connections.
If removed, install clip (3) on hose assembly (4).
Install clip (3), located on hose assembly (4), Iockwasher (2), and screw (1) in air inlet housing
(5). Torque screw to 16-20 Ib-ft (22-27 N-m).
(3-61 blank)/3-62
Back to Top
