TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 345 of 596

b. Cleaning

TM 9-2815-205-34

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138°F (38-50°C). If you become dizzy while using cleaning

solvent, get fresh air immediately and seek medical aid. If contact with eyes is

made, wash with water and get medical aid immediately.

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only

with effective chip guarding and p&son-al protective equipment (goggles/shield,

gloves, etc.)

CAUTION

Always store liners in an upright position until ready for use. Liners left on their side can

become distorted.

Clean cylinder liner with cleaning solvent and dry with compressed air.

c. Inspection

(1)

(2)

(3)

(4)

Check outside of liner for cracks, scoring, and flange irregularities. Discard cracked or

excessively scored liners. Clean up lightly scored liners using cylinder hone.

NOT E

Excessive liner to block clearance or block bore distortion will reduce heat transfer from

liner to block.

Examine outside surface for fretting. Remove metal particles from outer surface with

sharpening stone.

Liner flange must be smooth and flat on top and bottom surfaces. Replace if cracked at flange.

Check inside diameter of liner for glazing, cracking, scoring, and unusual wear. Replace

cracked, scuffed, or scored liners.

3-215