TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 126 of 968

TM 9-2815-210-34-2-2

FRAME 4

1.

2.

3.

4.

Check that neither face of camshaft thrust plate (1) is worn thin in places.

Check that neither face of camshaft thrust plate has grooves worn in it.

If either face of camshaft thrust plate (1) is groooved or badly worn down,

throw it away and get a new one.

WARNING

Dry cleaning solvent is flammable. Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

Check that neither face of camshaft thrust plate (1) has small nicks, scratches

or burrs.

To fix small nicks, scratches, and burrs, put crocus cloth soaked

in dry cleaning solvent on a flat surface.

Then rub face of camshaft thrust

plate against crocus cloth.

Measure thickness of camshaft thrust plate (1) near hole in center. Reading

must be within limits given in table 4-20.

If readings are not within given

limits, throw away camshaft thrust plate and get a new one.

GO TO FRAME 5

Table 4-20. Camshaft Thrust Plate Wear Limits

Size and Fit

Index

of New Parts

Wear Limit

Number

Item/Point of Measurement

(inches)

(inches)

1

Camshaft thrust plate thickness

0.2400 to 0.2420

0.2380

4-107