TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 128 of 968

TM 9-2815-210-34-2-2

FRAME 6

NOTE

Readings must be within limits given in table 4-21.

The letter T shows a tight fit. If readings are not

within given limits, throw away part and get a new

one.

1.

Measure inside diameter (1) of camshaft gear (2).

2.

Measure outside diameter (3) of front end of camshaft (4).

3. Measure fit of camshaft gear (2) on camshaft (4).

GO TO FRAME 7

Index

Number

1

3

2

and

4

Table 4-21. Camshaft Gear Wear Limits

Item/Point of Measurement

Camshaft gear inside diameter

Camshaft front end out side

diameter

Fit of camshaft gear on

camshaft

Size and Fit

of New Parts

(inches)

1.3744 to 1.3799

1.3752 to 1.3758

0.0003T to 0.0014T

Wear Limit

(inches)

None

None

None

4-109