TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 154 of 968

TM 9-2815-210-34-2-2

FRAME 2

1. Check that six screws (1) are not stripped or damaged. If any screw is

damaged, get a new screw.

2. If rear oil seal housing (2) is not damaged and can be used again, check

whether it has one oil drain hole (3) or three oil drain holes (3 and 4).

3. If real oil seal housing (2) has only one oil drain hole (3), tell machine shop

to drill two more drain holes (4).

See Figure 4-1.

END OF TASK

4-135