TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 145 of 968

TM 9-2815-210-34-2-2

h .

Replacement of Expansions Plugs, Pipe Plugs, and Crankcase to Cylinder

Head Studs.

FRAME 1

1.

If expansion plug (1) behind identification plate (2) was taken out, coat

new expansion plug with sealer.

Then knock in new expansion plug using

mallet and short brass rod until they are about 1/8-inch below surface of

crankcase (3).

2.

Line up four holes in identification plate (2) with mounting holes for

identification plate in crankcase (3). Using hammer, tap in four straight

pins (4).

3.

Put in crankcase to cylinder head studs (5).

GO TO FRAME 2

4-126