TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 25 of 968
TM 9-2815-210-34-2-2
FRAME 3
1.
2.
3.
END
NOTE
There is an expansion plug (1) behind identification
plate (2).
Identification plate should not be taken
off unless there are signs of coolant leakage under
it.
Coolant leakage around expansion plug (1) will show
up as rust, scale or stain on side of crankcase (3)
below expansion plug.
Check that there is no sign of leakage below identification plate (2).
If there are signs of leakage below identification plate (2), take it off
using hammer and cold chisel.
If identification plate (2) was taken off, mark expansion plug (1) for removal.
OF TASK
4-6
Back to Top
