TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 52 of 968
TM 9-2815-210-34-2-2
FRAME 17
1.
2.
3.
4.
5.
NOTE
Readings must be within limits given in table 4-3. The
letter T shows a tight fit. If readings are not within
given limits, throw away part and get a new one.
Using gage (1) (internal measuring set) and outside micrometer (2),
measure crankshaft pilot bearing inside diameter (3).
Using outside micrometer (2), measure crankshaft pilot bearing outside
diameter (4).
Using gage (1) and outside micrometer (2), measure inside diameter of
crankshaft pilot bearing bore (5).
Measure fit of crankshaft pilot bearing outside diameter (4) in crankshaft
pilot bearing bore (5).
Using heavy hammer and bearing installing tool with a pilot diameter of
0.7503 inch, put in new crankshaft pilot bearing (3).
GO TO FRAME 18
4-33
Back to Top
