TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 45 of 968
TM 9-2815-210-34-2-2
FRAME 1 0
WARNING
1.
2.
3.
4.
5.
6.
Dry cleaning solvent is flammable. Do not use near an
open flame. Keep a fire extinguisher nearby when sol-
vent is used.
Use only in well-ventilated places. Fail-
ure to do this may result in injury to personnel and
damage to equipment.
Check that crankshaft damper and pulley (1) has no nicks, scratches or
burrs .
Fix small nicks, scratches, and burrs with a fine mill file or crocus
cloth dipped in dry cleaning solvent.
Take out keyway seal (2) and check that keyway in crankshaft damper and
pulley (1) has no burrs or cracks.
Fix small burrs with a fine mill file.
If keyway is cracked or badly damaged, throw away crankshaft damper
and pulley and get a new one.
Put back keyway seal (2) so it is not lost.
Check that threads in two puller screw holes (3) are not damaged. Fix minor
thread damage with a tap.
If threads are badly damaged, throw away crank-
shaft damper and pulley (1) and get a new one.
Check that lockplate (4) is not cracked or broken. If it is cracked or broken,
throw it away and get a new one.
Check that three screws (5) and three washers (6) are not damaged. If they
are damaged, throw them away and get new ones.
IF WORKING ON ENGINE LDS-465-2, GO TO FRAME 11.
IF WORKING ON ANY ENGINE EXCEPT LDS-465-2, GO TO FRAME 12
4-26
Back to Top
