TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 41 of 968
TM 9-2815-210-34-2-2
FRAME 6
1.
2.
3.
4.
5.
6.
Check that
burrs with
Check that
Dry cleaning
near an open
nearby when
WARNING
solvent is flammable. Do not use
flame. Keep a fire extinguisher
solvent is used.
Use only in well-
ventilated places.
Failure to do this may result
in injury to personnel and damage to equipment.
dowel pins (1) have no nicks, scratches or burrs. Fix minor
a fine mill file or crocus cloth dipped in cleaning solvent.
dowel pins (1) are not cracked, broken or loose.
If either of two dowel pins (1) is cracked, broken or loose, pull it out
using dowel pin puller.
Using soft-faced hammer, tap in new dowel pin (1) until dowel pin bottoms
in hole.
Check that all crankcase-to-cylinder-head studs (2) are not stripped,
cracked, or broken.
If crankcase-to-cylinder-head studs (2) are damaged, get new ones.
GO TO FRAME 7
4-22
Back to Top
