TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 524 of 968

TM 9-2815-210-34-2-2
FRAME 3
1.
Measure
2.
Measure
3.
Measure
4.
Measure
5.
Measure
NOTE
Readings must be within limits given in table 4-64. If
readings are not within given limits, throw away part
and get a new one.
arm assembly bore (1).
diameter of fan idler shaft (2).
sleeve bushing outside diameter (3).
bearing outside diameter (4) and inside diameter (5).
inside diameter of grooved pulley (6).
GO TO FRAME 4
Index
Number
1
2
3
4
5
6
Table 4-64. Fan Idler Pulley and Arm Assembly Wear Limits
Item /Point of Measurement
Arm assembly bore
Fan Idler shaft diameter
Sleeve bushing outside diameter
Bearing outside diameter
Bearing inside diameter
Grooved pulley inside diameter
Size and Fit
of New Parts
(inches)
1.1220 to 1.1250
0.7873 to 0.7877
1.1200 to 1.1210
2.0467 to 2.0472
0.7870 to 0.7874
2.0460 to 2.0472
Wear Limit
(inches)
1.1280
None
1.1170
None
None
None
4-505


Back to Top