TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 19 of 192
*TM 9-2815-213-34
a.
Using a suitable hoisting device, (i.e., over-head
chain fall, A frame hoist, or gooseneck hoist), attach
lifting hooks to engine front and rear lifting eyes, (figs. 1-
1 and 1-2) and raise engine.
b.
Remove eight capscrews, spacers, and four
lockplates, securing left bank exhaust manifold to head.
c.
Remove manifold and four manifold to block
gaskets (fig. 21).
Figure 2-1. Exhaust mainifold--removal/installation.
d.
Remove
13
capscrews
and
lockwashers
securing oil cooler to engine (fig. 2-2).
e.
Remove oil cooler and four gaskets.
f.
Remove 12 capscrews, lockwashers, and one
gasket, securing cover plate to block and remove plate.
g.
Install engine rebuild stand and adapter (26 and
27, fig. B-28) to engine block as shown in figure 2-3.
h.
Remove hoisting equipment.
2-10.
External Components
a.
Starter Assembly.
Remove three capscrews and
lockwashers securing starter to flywheel housing, and
remove starter.
b.
Exhaust
Ma_tifold-Right
Bank.
Remove eight
capscrews, spacers, four lockplates and four gaskets
securing manifold to head.
c.
Alternator Assembly.
(1) Disconnect electrical connector.
(2) Remove belt tension adjusting arm bolt.
(3) Remove two capscrews, and lockwashers
securing alternator to mounting bracket and remove
alternator.
(4) Remove four capscrews, lockwashers, and flat
washers securing mounting bracket to intake manifold.
(5) Remove capscrew and lockwasher securing fan
assembly mounting bracket to alternator mounting
bracket.
(6) Remove capscrew, lockwasher and flat washer
securing tension adjusting arm to block. Remove arm.
d.
Hydraulic Pump
Assembly.
NOTE
If engine is received for repair without
the power steering pump (hydraulic
pump), bracket, pulley and drive belt, do
not requisition these items for installation
on the repaired engine. The rebuilt
engine will be shipped to the using unit
without the pump assembly.
2-4
Back to Top
