TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 476 of 801

TM 9-2320-273-34

be certain of a snug

spider trunnions.

Tighten case bolts to a torque of 85-115 Ib-ft (115-156 N•m) (fig. 11-28). Check to

fit between the two case halves at all points and between the holes in case and the

TA 074322

Figure 11-28. Assemble the Case and Ring Gear Assembly.

(4)

If roller bearings and bearing cones have been removed, press cone onto each end of

assembly using a suitable sleeve.

c.

Install Differential and Gear Assembly.

(1)Pre-lubricate

differential bearings and cups with the recommended axle lubricant.

(2)

Place

CUPS

over bearings and position assembly in carrier housing.

(3)

Insert the bearing adjusting nuts and turn handtight against bearing cups.

In step (4), if the bearing caps do not

position properly, adjusting nuts might be

cross-threaded. Remove caps and reposi-

tion the adjusting nuts. Forcing caps into

position will result in irreparable damage

to the carrier housing or bearing caps.

CAUTION

11-30