TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 477 of 801

TM 9-2320-273-34

(4)

Install the bearing caps (fig. 11-29) in the correct location as marked and tap lightly into

position.

(5) Install

(6)

Install

Figure 11-29. Install Differential and Gear Assembly.

the carrier leg capscrews and washers and torque to 290-350 Ib-ft (393-475 N•m),

the adjusting nut. (Cotter keys will be installed after final adjustments are made. )

d. Adjust the Differential Bearing Preload.

(1)

Using a dial indicator at the backface of the gear (fig. 11-30), loosen the bearing adjusting

nut on

the side opposite gear on/y

sufficient to notice end play on the indicator.

Figure 11-30. Adjust Differential Bearing Pre-Load.

(2)

Tighten the same adjusting ring only sufficient to obtain 0.000 end play.

(3)

Check the gear for run-out.

If run-out exceeds 0.008 in. (0.203 mm), remove the differen-

tial and check for cause.

11-31