TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

  TM-9-2320-328-13-P-2 - Page 724 of 1390

TM 9-2320-328-13&P-2
0210-4
DRAFT
0210
Change 1
CALIBRATION
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Vehicle engine must be turned off and all water pressure relieved from system
before performing the following procedures.
Failure to comply may cause injury to
personnel.
1.
Connect batteries (TM 9-2320-325-14&P).
2.
Push battery disconnect switch to on position (WP 0007).
NOTE
Both electric valve control meters are calibrated the same way.
No. 2 passenger side
discharge electric valve control meter shown.
3.
Push both FLOW button (1) and PRESSURE button (2) simultaneously until the display flashes CAL.
4.
Release FLOW button (1) and PRESSURE button (2) and display will flash 5I2E (SIZE).
5.
Three mode lights GPM (3), TOTAL (4), and PSI (5) will be illuminated when 5I2E (SIZE) flashes.
HWT3402
WARNING
ICON 72


Back to Top