TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 380 of 528

TM 9-2330-356-14

7-32. Gear Cover Assembly

Remove blower housing (para 7-14) if removal is

done with engine attached to vehicle.

b.

Remove governor arm (3, fig. 7-14) by loosening

screw (3, fig. 7-28).

c.

Remove flywheel assembly (para 7-27).

Remove four screws (1, fig. 7-31), lockwashers

(2), screw (3), and lockwasher (4) holding gear cover(5) to

crankcase. Remove two screws (31), lockwashers (30),

cover (29), and gasket (28). Tape crankshaft keyway to

prevent damage to seal (11, fig. 7-28). To loosen gear

cover, tap it with a soft hammer. Remove gasket (6,

fig. 7-31).

7-33. Governor Cup (Figs. 7-29 and 7-30)

a.

Remove retaining ring (fig. 7-30) from camshaft

center pin.

NOTE

Be sure to catch the ten flyballs that will fall

out when cup is removed.

b.

Slide governor cup off camshaft center pin.

Figure 7-28. Gear Cover Components.

7-24