TM-9-2330-356-14

SEMITRAILER, TANK: 5000 GALLON, BULK HAUL, SELF LOAD/UNLOAD M967 AND M967A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, AUTOMOTIVE M969 AND M969A1; SEMITRAILER, TANK: 5000 GALLON, FUEL DISPENSING, UNDER/OVERWING AIRCRAFT M970 AND M970A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1990

TM-9-2330-356-14 - Page 412 of 528

TM 9-2330-356-14

Figure 7-62. Electric Starter Assembly.

(3)

Remove through bolts (10) and lockwashers

(11), and remove backplate assembly (12) and thrust

washers (21). Remove nuts and washers (13) from brush

assembly (15). Raise brush spring (14), and lift brushes (15)

from brush holder. Remove screws (16) and lockwashers

(17), and remove brush holder (18). Raise springs (14) and

lift other brushes from brush holder. Remove springs (14)

from brush holder.

(4)

Remove retainer (23), boot (24), and pin (25).

Separate pinion housing (22) and frame assembly (19). Do

not lose thrust washer (21). Remove other set of brushes

(20) by cutting leads l-inch on each side of welded

connection (fig. 7-63).

(5)

Remove yoke (26), and remove armature (27)

and drive assembly (29). Remove lock ring and stop (28) by

pressing stop toward armature until lock ring becomes

accessible. Remove lock ring (28) and drive assembly (29)

from armature (27). Do not disassemble drive assembly.

b.

Cleaning and Inspection.

WARNING

Dry cleaning solvent P-D-680 Is toxic and

flammable.

Always wear protective

goggles and gloves, and use only in a

well-ventilated area. Avoid contact with

skin, eyes, and clothes, and DO NOT

breathe vapors. DO NOT use near open

flame or excessive heat. The solvent’s

flash point is 100°F-138°F (38°C-59°C).

If you become dizzy while using cleaning

solvent, immediately get fresh air and

medical help. If solvent contacts eyes,

7-56